BMPKB - SYNTHETIC GRAPHITE: GRADE
- MSDS: BMPKB
- Manufacturer: POCO GRAPHITE INC
- Product Name: SYNTHETIC GRAPHITE: GRADE
- National Stock Number: 9620-00N025295
Product Identification
Product ID:SYNTHETIC GRAPHITE: GRADE
MSDS Date:10/24/1989
FSC:9620
NIIN:00N025295
MSDS Number: BMPKB
Responsible Party
DECATUR, TX 76234
US
Emergency Phone: 800-356-3129;800-424-9300(CHEMTREC)
Info Phone: 817-627-2121
Cage: FO975
Contractor
Telephone: 817-627-2121/202-483-7616
Cage: 53241
Ingredients
EXPOSURE LIMIT. DO NOT WEAR CONTAMINATED
RTECS: 9999999ZZ
GRAPHITE
CAS: 7782-42-5
RTECS: MD9659600
OSHA PEL 15 MPPCF RDUST
ACGIH TLV: 2 MG/M3 RDUST; 9293
NUISANCE DUST
OSHA PEL 15 MG/M3
ACGIH TLV: 10 MG/M3
NUISANCE DUST, RESPIRABLE
OSHA PEL 5 MG/M3
PROT AS CNDTNS WARRENT. MINIMIZE DUST
RTECS: 9999999ZZ
SHOULD INSURE MIN DUST; VACUUM DUST RATHER THAN
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYE: CNTCT W/DUSTS MAY BE ABRASIVE &
IRRIT TO EYES & MAY CAUSE STINGING, TEARING & REDNESS. SKIN: THIS
MATL IS NOT EXPECTED CAUSE SKIN IRRIT. INHAL: PRLNG/RPTD OVEREXP TO
DUSTS MAY RSLT IN CHRONIC BRO NCHITIS (LUNG INFLAMMATION) W/SYMP OF
COUGHING & SHORTNESS OF BREATH. INGEST: NO HARMFUL EFTS ARE (EFTS
OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: EXPECTED FROM INGESTION OF THIS
MATERIAL.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:EYE:IF IRRIT/REDNESS DEVELOPS, MOVE VICTIM AWAY FROM EXPOS &
INTO FRESH AIR. FLUSH W/CLEAN H2O FOR @ LST 15 MIN. IF SYMP
PERSIST, SEEK MED ATTN. SKIN:FIRST AID IS NOT NORMALLY REQUIRED.
HOWEVER, IT IS GOOD PRACTICE TO WASH ANY CHEM FROM SKIN. INHAL:IF
RESP SYMP DEVELOP, MOVE VICTIM AWAY FROM SOURCE OF EXPOS & INTO
FRESH AIR. IF SYMP PERSIST, SEEK MED ATTN. IF VICTIM IS NOT BRTHG,
(SUPP DATA)
Fire Fighting
Extinguishing Media:DRY CHEMICAL, FOAM, WATER OR SAND IS RECOMMENDED.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
. STOP SPILL/RELEASE IF IT CAN BE DONE WITHOUT RISK. H2O SPRAY MAY
BE USEFUL IN MINIMIZING OR (SUPP DATA)
Unusual Fire/Explosion Hazard:THIS MATERIAL MAY BURN, BUT WILL NOT
IGNITE READILY.
Accidental Release
Spill Release Procedures:MAY IGNIT. KEEP ALL SOURCES OF IGNIT AWAY FROM
SPILL/RELEASE. STAY UPWIND & AWAY FROM SPILL/RELASE. ISOLATE HAZ
AREA & LIMIT ENTRY TO AUTHORIZED PERSONNEL. STOP SPILL/RELEASE IF
IT CAN BE DONE WITHOUT RISK. WEAR APPROP PROT EQUIP INCL RESP(ING
4)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:USE AND STORE THIS MATL IN COOL, DRY,
WELL VENT AREAS AWAY FROM HEAT & ALL SOURCES OF IGNITION. KEEP
CNTNR(S) CLSD. STORE ONLY IN APPRVD CNTNRS.
Other Precautions:KEEP AWAY FROM INCOMPATIBLE MATLS. PROT CNTNR(S)
AGAINST PHYSICAL DMG. DO NOT ENTER CONFINED SPACES SUCH AS
TANKS/PITS W/OUT FOLLOWING PROPER ENTRY PROC SUCH AS ASTM D-4276.
THE USE OF RESP PROT IS AD VISED WHEN CONC EXCEED THE ESTAB (ING 6)
Exposure Controls
Respiratory Protection:IF AIRBORNE CONCENTRATIONS EXCEED ESTABLISHED
EXPOS LIMITS, A NIOSH/MSHA APPROVED SUITABLE FILTER TYPE RESPIRATOR
SHOULD BE WORN.
Ventilation:IF CURRENT VENT PRAC ARE NOT ADEQ TO MAINTAIN AIRBORNE CONC
BELOW ESTAB EXPOS LIMITS, ADDNL VENT/EXHST SYS MAY BE REQ.
Protective Gloves:IMPERMEABLE GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:IT IS SUGGESTED THAT A SOURCE OF CLEAN H2O
BE AVAIL IN WORK AREA FOR FLUSHING EYES & SKIN. WEAR IMPERVIOUS
CLTHG.
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING. USE GOOD
PERSONAL HYGIENE PRACTICE.
Supplemental Safety and Health
FIRE FIGHT PROC: DISPERSING VAPS AND COOLING EQUIPMENT EXPOSED TO HEAT
AND FLAME. FIRST AID PROC: IMMED BEGIN ARTF RESP. IF BRTHG DFCLTS
DEVELOP, O2 SHOULD BE ADMIN BY QUALIFIED PERSONNEL. SEEK IMMED MED
ATTN. INGEST: NO FIRST AID IS NORMALLY REQUIRED; HOWEVER, IF
SWALLOWED, AND SYMP DEVELOP, SEEK MED ATTN.
Chemical Properties
HCC:N1
Boiling Pt:B.P. Text:>6600F
Appearance and Odor:STEEL GREY TO BLACK SOLID, NO ODOR
Stability
Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE KNOWN.
Hazardous Decomposition Products:COMBUSTION OF ORGANIC MATERIALS
PRODUCES CARBON DIOXIDE AND POSSIBLY CARBON MONOXIDE.
Disposal
Waste Disposal Methods:DISPOSE OF PRODUCT IN ACCORDANCE WITH LOCAL,
COUNTY, STATE AND FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.